Did some glass back in the day...





But now it's time to redo..

Dash cover, new rear deck setup, one piece trunk setup, glassed pillars... gonna smooth out all the plastic pieces and paint them, too.

Hopefully re-upholster the door panels and seats too..

One side of the subs was a little unever.. remade that box..



Rear deck part.




Trunk setup..



couples of the pillars..


dash cover..


Switch extenders on the window switches!

Haven't had a camera for a while, but I bought a new phone finally... Don't have a lot of good progress pics, but I snapped a few random ones with the new phone camera.

Found a place to do my whole interior like I wanted... lil more than I wanted to pay, but less than everyone else quoted. Gonna take the stuff down probably week after Christmas.

So that lit a fire under me to get going on the rest.. been sanding my plastic parts in my basement lately..


Sanded stuff.

stuff needing sanding.



Gonna glass this all into one piece then paint... it'll flow right into the way the dash it done, should be pretty cool.


Seats in my room

And experimenting around before I cut into the re-upholstered ones.


And the new green coolant


The fiberglassed pillars are almost ready for high build primer and pinhole filling... have one layer of body filler on the trunk and rear window piece.. The dash-top is about halfway there.

Eh, I'll post pics as I go. The goal is everything to be done painted, car repainted, then put back together by 2nd week in May.

Oops, gonna paint it again



Rough mockup of visor screen


Putting little baby screens where the rear vents were.. first night of fab on those. Sweet blurry picture.

Said screw it and did some bodyfiller work in the basement.. hehe.


finished up the door sill panels.. red spots in the first pic are low spots.



Big pile of plastics ready for high build primer


Beefy check valves

Said screw it and did some bodyfiller work in the basement.. hehe.


finished up the door sill panels.. red spots in the first pic are low spots.



Big pile of plastics ready for high build primer


Beefy check valves

Sand sand sand sand

fixing a few edges on the trunk piece


Finally primer time on the plastic pieces and a couple fiberglass bits



I need to buy more tables

Sanded down primer.. time for paint on some pieces, and one last primer coat on some of the others.



Now to finish the bodywork on the big fiberglass pieces.

Gettin there, everything's in primer, smeared a ton of spot putty over the pinholes.. And got two of the primered parts sanded ready for another coat so far.




Checked the fit before primer


Molding in the amp rack piece... decided it couldn't be a 2 piece ordeal, no sir.



Also, headliner

Started dying the carpets.. this is the first day, they're all blue now though.

Ok here's some pics for you guys.